gcotterl wrote:
On Jun 9, 5:45 am, "HeyBub" wrote:
gcotterl wrote:
How do I prevent finish nails from bending when I hammer then nails
through pre-drilled holes in quarter-round oak molding into drywall?
(I'm not using a brad-nailer).

Use a brad nailer. A perfectly acceptable one is available from HF
for under $20. Once you get a brad nailer, you'll use your hammer
for pounding everything EXCEPT nails.

'Course you'll need a compressor, too.

Buying a brad nailer and a compressor doesn't make economic sense
since I have only 26 feet of molding to install.

Okay, get a brad nailer and a compressed air tank. Fill the tank at the gas
station or off a friend's compressor. Tank should cost about $25.00.


Getting a good, straight swing with the hammer is hard because I'm
bending over countertops and ducking under wall cabinets.

All the more reason for a brad nailer, etc. You've got more than $150 worth
of aggravation otherwise.