On Jun 4, 11:55*am, "RogerT" wrote:
Bob Villa wrote:

It was a wasp net and involved a near complete tear-apart! Very bad
design!

Interesting. *Just guessing here, but was the wasp nest causing a blockage
of air flow, then the unit would overheat, then an overheating sensor
somewhere would cut it off? *Then, after it cooled down it would work again?

The nest is like cardboard and would make a slight noise most of the
time and every once in a while would jam. The compressor would not
cool enough and drop-out. Then the compressor would go thru another
cycle if the fan wasn't running.
Those nests are tough to rip-apart!

http://timberpest.com.au/images/wasp%20nest.jpg