On May 6, 10:47*am, "James" wrote:
Will a *12 inch, *non-reciprocating miter saw cut *6 *x 6 * beams in one
pass ??? * *I know it would be close, but I would like to hear from someone
who has done it. *Again, can it cut in one pass, so as to get a perfectly
smooth cut ?

Thanks !!

James

If I had a large number of them to do I would lay out all the cut
lines on them a lay them side by side then cut as many as I could in
one pass with a circular saw then flip and cut the other side. Will
probably take a 12 in saw to do it in two passes without having to
finish with a hand saw .....dont think they are terribly expensive to
rent.

Jimmie