http://www.canadiantire.ca/AST/brows....jsp?locale=en

http://www.canadiantire.ca/AST/brows....jsp?locale=en

----------------------

"Wayne" wrote in message ...

My lawn mower blades get dinged up real good by sticks and small rocks.
Grinding them takes me a long time, 2 blades, 4 edges.
Is there any reason why I couldn't set up the angle in the mill
and clean them up with an end mill?
I would think this would be a lot faster.
I could always grind in the final edge.

If this isn't a good idea, then everyone should forget I asked a stupid
question.

Wayne D.