Yup, they should, as long as they're not too deep. If they're deep, sand the
whole thing down and re-do it...it;s not as bad as it seems.

Good luck
Rob

--



******PLEASE NOTE OUR NEW EMAIL ADDRESS******



Please visit our (recently updated) web site:
http://www.robswoodworking.com

"BeerBoy" wrote in message
news:hzzVb.440347$X%5.150214@pd7tw2no...
What about the swirl marks? Will these come out when I scuff and wax it?

"Rob Stokes" wrote in message
news:lzyVb.10341$7Q1.7291@clgrps12...
Put it on, wait a few minutes, wipe ot off. Wait a few hours and repeat.
Repeat. Repeat Etc.... On the last coat, you can leave it "thick" and
scuff
it (320grit) later before you wax it OR....keep adding coats by wipe-on,
wipe-off.

Good luck
Rob

--



******PLEASE NOTE OUR NEW EMAIL ADDRESS******



Please visit our (recently updated) web site:
http://www.robswoodworking.com

"BeerBoy" wrote in message
news:ibyVb.439906$X%5.150304@pd7tw2no...
Hello,
I'm using wipe on poly for the first time and seem to be getting a lot
of
visible swirl marks after it is dry. Do I need to worry about these
or
will
I be able to buff them out on the last coat? Is there a better way to
apply
it?
Thanks.

--
BeerBoy