On Mon, 25 Apr 2011 17:38:18 -0700, Gunner Asch
wrote:
On Mon, 25 Apr 2011 17:07:07 -0500, Ignoramus14081
wrote:
On 2011-04-25, Chas wrote:
"Ignoramus28268" wrote in message
...
Here's a new video of it running, including burning a whole 6013
welding rod:
http://www.youtube.com/watch?v=uLEhOs3ivSQ
Iggy, that looks like a lot of satisfaction. I have no knowledge of that
particular generator, but watching and listening to the video I sense that
the motor is slowing down severely under the welding load. Does the motor
have a governor mechanism to maintain speed under load conditions? If so, I
suspect you might need to perform a repair and/or adjustment. There is
normally a centrifugally driven connection to the throttle. Someone else in
the group might be able to advise.
There is a speed control (idle control) board. I have a feeling that
it may not be wired right.
i
Here..this may help
http://www.weldmart.com/technical/SA200IdlerTS.htm
I could have sworn that was the bellows type in his pics. If not,
you're spot on, suh.
--
Make up your mind to act decidedly and take the consequences.
No good is ever done in this world by hesitation.
-- Thomas H. Huxley