The Natural Philosopher expressed precisely :
SRT wrote:
Hi,
As in header. I have a Haws traditional can that's just about 2 years old
(birthday present)
Unfortunately I noticed the centre of the base had pushed out causing it to
rock around ( maybe frost?)
so I tapped it back into line and now see a slight weep/leak from the
welding around the base
Any ideas as to best way if any to repair?
Thanks.
Stuart.

plumbers solder and blowlamp/plumbers flux.

That will not 'take' on a galv finish. I don't think they even solder
them when new - I think they just fold the base/sides together, then
rely on the galv dip to provide the final seal.

I would be inclined to suggest running some paint around the inside
lip, hoping it were thin enough to make its way into the leak point and
seal it.

--
Regards,
Harry (M1BYT) (L)
http://www.ukradioamateur.co.uk