On Thu, 31 Mar 2011 07:13:41 -0700, Winston
wrote:

wrote:

(...)

You'd get a lot more joints out of that ounce of flux and filler than
out of a similar quantity of filler rod and a jar of flux by the time
you clean up the joint. The stuff is really meant for furnace
brazing, though, where you have your parts rolling through on a belt
instead of guy with a torch doing onesies. I've used it for gun work
for putting sights and ramps on, good stuff. Just a mite spendy in
today's metal market.


In just a few minutes of searching, I found a blade that will
do the job for about 50% more than the Irwin blades HF
used to sell:
http://www.toolbarn.com/bosch-cb1260.html

Another one in the running, $35.18 UPS. (prolly 3+ weeks)
http://goo.gl/ClUPr Makita 12" 40T thin kerf.

Does anyone here have experience with www.eReplacementParts.com ?

--
You and I have a rendezvous with destiny. We will
preserve for our children this, the last best hope
of man on Earth, or we will sentence them to take
the last step into a thousand years of darkness.?
-- Ronald Reagan