On Wed, 30 Mar 2011 15:39:32 -0700, Winston
wrote:

Larry Jaques wrote:
On Wed, 30 Mar 2011 12:26:45 -0700,
wrote:

Larry Jaques wrote:

(...)

If one joint failed, the rest may be ready.

Also, the replacement teeth are guaranteed to be differently -
shaped than the worn teeth, making sharpening a much more
time-consuming process than it needs to be.

I suppose size/weight could have some implications here, too. Put a
single different sized tooth on and throw the blade out of dynamic
balance.

I wouldn't be too concerned there.

On my dry saw, I've discovered that I'd been cutting steel using
a blade missing a couple teeth. Performance was down.
but it still worked without discernible vibration.

Doesn't your dry saw run at a considerably slower RPM?


My nit is that they never showed any additional silver solder being
applied. Is there enough after removing the teeth? I'd be wary of
that.

He *implies* that he put fresh silver solder in the joint
between shots. (Must look up silver solder *paste*!)

Powdered silver solder in white flux, just what we need.

Substitute black flux and you've got a deal!

(What?)

FIFTY BUCKS AN OUNCE?! Nevermind.

Fifty bucks an ouch?

--
The general effect was exactly like a microscopic view of a
small detachment of black beetles, in search of a dead rat.
-- John Ruskin