U joint installation. Is this ring seated?
On Mar 15, 11:00*am, Jim Wilkins wrote:
On Mar 15, 11:23*am, stryped wrote:
On Mar 15, 7:45*am, Jim Wilkins wrote:
On Mar 15, 8:33*am, stryped wrote:
One more question. I have installed a u joint. I am not sure one side
snap ring is fully seated. ...
Use a small drill bit as a gage to compare the visible height of the
rings or the end gaps.
jsw
Would it be ok to slightly grind the diameter of the ring? I seem to
have tried everything.
Scrape the groove clean and remove any burrs on the edge.
jsw
Update:
Just for kicks I measured the old clips and new ones. an old clip was .
056 thick. New ones were .059. Times two this would be .003. Could
this cause the problem I am having?
|