Clap, clap clap! That idea is a keeper in case I ever need it.

-----
Regards,
Carl Ijames

"Christopher Tidy" wrote in message
...
You know when you want to extract a short, unbroken stud from a casting
without damaging it, but it's stuck tight? Well I never found a good way.
But I had an idea this afternoon. I took a hex nut, cut a radial slit
through the nut, screwed it onto the stud, and squeezed it tight in a mole
wrench (i.e., vise grips). So it worked a bit like a collet. It turned the
stud out easily. Here's a pictu
http://www.mythic-beasts.com/~cdt22/stud_extractor.jpg

No doubt some dude in Detroit had the same idea about 80 years ago, but I
was pleased with it :-).

Chris