On Sun, 06 Mar 2011 15:55:06 +0800, Man-wai Chang
put finger to keyboard and composed:

I would like to modify a dead mouse into a LED power. The chip would not
activate the LED input until the PC boots into Window$.

Could I short a few pins on the CP5609AMT to skip the detection of
Window$ and instantly turns on the LED input?

FWIW, this obsolescence document advises that the CP5609AMT and
CP5605AM devices have been replaced by the CY7C63613-SC:
http://www.datasheetarchive.com/pdf/...645.pdf&scan=n

CY7C63411/12/13, CY7C63511/12/13, CY7C63612/13 Low-speed USB
Peripheral Controller:
http://www.datasheetarchive.com/pdf/...5671.pdf&scan=

My cursory examination of the document would suggest that the
microcontroller may be waiting for a command over the USB interface
before it activates the LED. Otherwise one of the GPIO pins may have
the desired function, but this would be implemented in the firmware by
the designer of the mouse.

- Franc Zabkar
--
Please remove one 'i' from my address when replying by email.