On 2011-02-28, Pete C. wrote:
Ignoramus28206 wrote:
On 2011-02-28, PrecisionmachinisT wrote:
"PrecisionmachinisT" wrote in message
news:l9CdndkoY8SKQ_bQnZ2dnUVZ_rmdnZ2d@scnresearch. com...
AMC has a much better .pdf someplace in their tech litereature--explains
servo setup / tuning theory from a generic viewpoint sorry I don't have
time to look for it at the moment maybe later.
http://www.a-m-c.com/download/manual...tallManual.pdf
Yes. Thank you. Note though, that I am not even trying to tune it. I
was just trying to get maximum output out of it.
i
Have you tried running the motor from the drive with the motor
disconnected from the table?
No, but this is a great question. I may do it.
i