Cutting Linear Motion Shaft Without Distorttion
On Dec 6, 2:31*am, "Bob La Londe" wrote:
Not sure if its even an issue, but I was wondering if I cut a 1" precision
linear shaft with something like a chop saw if I would distort and ruin a
portion of it from the heat. *If in doubt use the hacksaw I suppose.
I need two 20" pieces, but the best price I found was for a single 63"
piece. *I suppose I could also just cut them a little bit long and let them
stick out on the open end.
Are you planning to run the bearings ALL the way to the end?
You will not likely run into the very end that was cut off if you have
any margin in the design.
|