In article ,
says...

On Thu, 2 Dec 2010 23:33:03 -0500, Steve
wrote:

On 2010-12-02 21:20:28 -0500, Bill said:

Was looking for a set of decent brad point drill bits. I found this
Craftsman set:

http://www.sears.com/shc/s/p_10153_1...block Type=G2


I

know not everyone speaks highly of Craftsman quality... I'm hoping that
since they are 6 for $40, there are quite good (3/8" shanks). I get
wary when I see bits for between a quarter and $2 each. I guess the
main issue might be "run out".

Where would you be shopping for brad point drill bits (for joinery)?

Thanks,
Bill

http://www.woodcraft.com/Product/208...Bit-Gauge.aspx

And

if that's too many...
At less than a quater each, average, they are likely high quality
Chinese bits. The TiN coating just makes them LOOK expensive and/or
good.

The actually work fine, the ones that aren't bent. At that price you
can afford to throw a few away.