On Thu, 2 Dec 2010 23:33:03 -0500, Steve
wrote:
On 2010-12-02 21:20:28 -0500, Bill said:
Was looking for a set of decent brad point drill bits. I found this
Craftsman set:
http://www.sears.com/shc/s/p_10153_1...block Type=G2
I
know not everyone speaks highly of Craftsman quality... I'm hoping that
since they are 6 for $40, there are quite good (3/8" shanks). I get
wary when I see bits for between a quarter and $2 each. I guess the
main issue might be "run out".
Where would you be shopping for brad point drill bits (for joinery)?
Thanks,
Bill
http://www.woodcraft.com/Product/208...Bit-Gauge.aspx
And
if that's too many...
At less than a quater each, average, they are likely high quality
Chinese bits. The TiN coating just makes them LOOK expensive and/or
good.