On 2010-11-26, Lloyd E. Sponenburgh lloydspinsidemindspring.com wrote:
FINALLY, I got my r2e4 Bridgeport converted to single-phase.

No more of that damned RPC singing over in the corner, no.

As it turns out, the R2E4 machine is basically a single-phase machine,
anyway, except for the spindle motor (which is definitely 3-phase).

The electronics all run off two (single) phases of the incoming power,
and there are no references to the phases. All it took to get them
converted was to move a couple of leads.

To adapt the spindle, I installed a VFD and a relay isolator that would
track the F/R signals from the motor relays, and signal the VFD to
start/stop/forward/reverse.

It cost only $149 and some labor.

Now to make metal in the QUIET! G

LLoyd

Woohoo!

How is it working for you, is it convenient to program?

i
i