On 11/17/10 8:11 PM, -MIKE- wrote:
On 11/17/10 6:46 PM, Upscale wrote:
wrote in message
"What's wrong with a hand held drill to drill bench dog holes."

The only reply I can give to that is the dog holes have the potential
to be
drilled on an angle, as slight as that may be. With a router, you're
almost
guaranteed that the hole is going to be vertically cut.


IMO...
if you can't drill a hole straight enough for a bench dog hole, then you
shouldn't be woodworking. :-)

Ummm, he is woodworking from a wheel chair, their are limitations as to
his angles of attack on a project.

--
Froz...


The system will be down for 10 days for preventive maintenance.