On 11/17/10 6:55 PM, Upscale wrote:
I briefly considered using a brad point drill or perhaps a spade drill, but
since I'm unable to lean over the drill to put weight on it as well as to
easily eyeball a decent vertical entry point, my plunge router seems like
the obvious choice.


I wasn't considering your circumstances when suggesting the drill.
However, any drill bit would produce far less dust, which was your main
concern, no?

Do you know anyone with a right angle drill?
I think you would be able to produce adequate down force with one of
those.


--

-MIKE-

"Playing is not something I do at night, it's my function in life"
--Elvin Jones (1927-2004)
--
http://mikedrums.com

---remove "DOT" ^^^^ to reply