On 10/12/10 4:37 PM, Robatoy wrote:
On Oct 12, 5:14 pm, wrote:
On 10/12/10 2:31 PM, Robatoy wrote:

Hard to explain, I need to draw that up for you.... maybe not. You
want the upside seam to be vertical, not on any tangent of that 1/8".

You're saying the top of the surface of material should match up with
the apex of the curve in the cutter... the farthest point in or out in
the curve.
-MIKE-

You want the exit apex to be vertical, 90° to the surface. If you do
anything less or more than that, you will be feathering the edges,
lengthening/widening the edge. It would make sense to keep that as
tight as possible.
Your question, in itself, tells me you understand.

In between posts, I finally found a manual on the PC website for the
"system."


--

-MIKE-

"Playing is not something I do at night, it's my function in life"
--Elvin Jones (1927-2004)
--
http://mikedrums.com

---remove "DOT" ^^^^ to reply