On Mon, 12 Jan 2004 00:21:33 GMT, B a r r y B u r k e J r .
wrote:

On Sun, 11 Jan 2004 18:32:18 GMT, "Mark Jerde"
wrote:

Guy LaRochelle wrote:
What is the best way and what size is best for an outfeed table on a
table saw? I have a Unisaw. I just don't know if I should build a
seperate table (what size?) or if I should build an outfeed attached
to the table saw. What is everyone doing for this? Room is not really
a problem for me since I am working in a 40' X 40' size building but
its no use having it too big for nothing..........right? Regards. -Guy

I built a 4 ft deep by 6'6" wide separate table, with slots for miter
gauges and sleds. I will soon build a second table to add 2 ft to the
right side of the saw and outfeed table. My table weighs over 200
pounds, not including the tools stored on the shelf below it. There
is no need to attach it to the saw.

When I'm not cutting, the saw plus the table makes a great assembly
area. Mine is covered with white melamine, which glue will not stick
to.

Barry

i built my extention table from 6/4 white oak and covered it with
corian. im planing one day to make the rear table the same way but i
need more room first. skeez