On Sep 4, 10:13*pm, GeoLane at PTD dot NET GeoLane at PTD dot NET
wrote:
On Sat, 31 Jul 2010 05:26:58 -0700 (PDT), Jim Wilkins
...
The 0.24-0.4 set arrived yesterday. *A little disappointing. *It
arrived in a Harbor Freight quality red blow molded case with poorly
fitting interior compartments. *No instructions in the box. * The
anvils didn't quite have a good looking finish. *The supplied wrench
was a really sloppy fit on the tiny nut at the end. *The dial
indicator cosmetically looked identical to the one in the 0.4-07 set,
but did not have MHC on the face of the dial. *The measurements were
repeatable. *The poor case and the sloppy wrench detracted from what
is probably an OK gage. *...
RWL

I received the .2-.4 and .4-.7 ones together and both are of the same
decent quality, in red plastic boxes marked MHC. The instructions
don't apply to the small sizes and when I checked for better ones on
the website the smaller one was listed as on backorder, so apparently
you got a substitute.

jsw