Ignoramus32079 wrote:
On 2010-08-01, Pete C. wrote:
Ignoramus28671 wrote:
On 2010-08-01, Pete C. wrote:
Ignoramus28671 wrote:
On 2010-08-01, azotic wrote:
"Ignoramus28671" wrote in message
...
On 2010-07-31, Steve B wrote:
"Ignoramus28671" wrote in message
...
This one was a rental at a party where I am right now.
http://igor.chudov.com/tmp/Pig-Roaster.jpg
Would be great to make one like this.
The motors, this low RPM (5-8) are hard to find actually.
i
DC motor with a pwm controller should get you in the range.
With variable speed you could experiment with a variety of
different meats, poultry, fish, and veggies. Bodine dc gearhead
motors used to be fairly cheap on ebay. CNC cooker ?
Yes, and no, because you lose on the power. I am glad that Steve B
finds so many low RPM gearmotors. I never found any. I can buy one
from Steve if he wants to part with one. I need 5-15 RPM.
I can make my own custom sprockets now with CNC.
Yes, but unless they are particularly large, it's cheaper and easier to
just buy them, Tractor Supply and similar have common ones retail cheap,
and Surpluscenter and similar have full lines cheap for the ordering.
I already looked in surpluscenter and did not find any.
5-10 RPM gearmotors are VERY rare.
i
I was referring to sprockets.
Surpluscenter periodically has low RPM gear motors, their availability
varies.
I can make sprockets very easily now.
i
Not as easily as you think. Take a look at commercial sprockets and note
the profile of the teeth, they are not simple flat plate pieces, there
is an edge taper on both sides to allow the teeth to engage into the
chain without catching. If the teeth are flat, the chain is centered on
the sprocket, and the next chain link comes along and there is no
clearance into the chain opening and it can catch if the chain isn't
perfectly straight. The taper on the tooth allows it to fit into a non
perfectly centered chain and guide it into proper position. I believe
most of the commercial sprockets also have some heat treating to make
them more durable.