Thread
:
Making a ZCI for tablesaw
View Single Post
#
21
Posted to rec.woodworking
-MIKE-
external usenet poster
Posts: 5,721
Making a ZCI for tablesaw
On 7/21/10 3:19 PM,
wrote:
On Jul 21, 3:09 pm, wrote:
wrote in message
Put the globs of glue on the insert and then sand the globs to proper
thickness after they harden.
The hot glue I've always used is pretty easy to pop off.
Yeah it pops off easy.... but it is glue, right? And you are going to apply
it and squeeze it between an insert and the table saw tabs, and then how do
you pop it off if it has glued your insert in place?
A. Wax the TS insert fingers first?
B. Whack it from below?
C. Use the finger hole to pry it off?
D. Don't use epoxy?
E. All of the above?
Yeah, especially D. :-)
--
-MIKE-
"Playing is not something I do at night, it's my function in life"
--Elvin Jones (1927-2004)
--
http://mikedrums.com
---remove "DOT" ^^^^ to reply
Reply With Quote
-MIKE-
View Public Profile
Find all posts by -MIKE-