"Bob Engelhardt" wrote in message
...
Habitat has a HUGE steam heat boiler that needs to be cut into smaller
pieces. A gas torch is out - the manager is a cautious one. Is there
anything different about using a plasma cutter on cast iron? I wouldn't
think so, but I've never done it. I guess that you would get a lot of
soot in the cloud of vaporized iron.

Sounds like a job for a HUGE sledge hammer, some safety gear and lots, lots
and more lots of hearing protection.

Regards,
Joe Agro, Jr.
(800) 871-5022
01.908.542.0244
Automatic / Pneumatic Drills: http://www.AutoDrill.com
Multiple Spindle Drills: http://www.Multi-Drill.com
Production Tapping: http://Production-Tapping-Equipment.com/
Flagship Site: http://www.Drill-N-Tap.com
VIDEOS: http://www.youtube.com/user/AutoDrill
TWITTER: http://twitter.com/AutoDrill
FACEBOOK: http://tinyurl.com/AutoDrill-Facebook

V8013-R