"Larry Jaques" wrote in message
...
On Sun, 18 Jul 2010 19:28:40 -0700 (PDT), Father Haskell
wrote the following:

On Jul 18, 12:55 am, Robatoy wrote:
On Jul 18, 12:34 am, Bob AZ wrote:

All

I picked up a bunch of saw blades and two of them have a carbide tooth
missing. Are replacement teeth available to weld on or does this not
happen?

Thanks
Bob AZ

Any decent sharpening company can replace teeth. You do need to look
at cost though. It can get expensive.

It *might* be possible to run them with one or two teeth missing.

OH, sure, Ollie. Yust knock one off d opposite side, ya.


ROTFL!!