How to protect (low voltage?) wire on TOP of concrete driveway in slot
Elmo wrote in
:
On Wed, 07 Jul 2010 14:32:16 GMT, Reno wrote:
Like any other sealant or glue job it is absolutely necessary to
clean all surfaces or even the best sealants won't stick.
I'm going to clean the crack with a pressure washer.
That should clean it well enough, don't you think?
Yes, that will clean it well. It needs to be dry, too, so either wait a
while or use compressed air or a heat gun to dry it out. Some compressors
add a lot of oil to the air which would prevent the sealant from sticking
so check yours by blowing air onto a clean towel.
|