On Fri, 04 Jun 2010 21:36:06 -0700, Smitty Two
wrote:

In article ,
Nate Nagel wrote:

yeah, if you have a drill bit that will drill through a decent tap... I
want some!

nate

Solid carbide, Nate. Actually an end mill is a better choice, assuming
you've got a milling machine handy.

You have to be kidding. Have you ever even set foot into a machine
shop?

Videos are cheap to make and post. Show me a tap that you can drill
out. Then mill one out. This should be easy for you. You have said
you've done it many times.