On Jun 3, 6:18*am, Puckdropper puckdropper(at)yahoo(dot)com wrote:
I have a approximately 20x30 space for my shop. *I've been working on
designing where all the tools will go, and would like some feedback on the
design.
y

I would have put my cutoff saw along the longest (back) wall.

It seems the jointer\planer would be in the way of you are breaking
down full sheets of ply but maybe not if they are low enough

If you start much with rough lumber then I would suggest a good
triangle of jointer, planer, table saw.

- Joint one face of each piece and stack convenient to planer
- Plane opposite face stacking back by jointer
- Run one edge on jointer, stacking by TS
- Rip other edge of each piece for final square up.