On May 18, 10:20*am, DerbyDad03 wrote:
On May 18, 8:10*am, jamesgangnc wrote:





On May 18, 6:55*am, ransley wrote:

On May 17, 10:45*am, DerbyDad03 wrote:

I need some advice from the small engine gurus in this group.

The History:

My Ryobi 340BV blower ran fine all during the fall. Towards the end of
the season, I had started it multiple times over the course of a
couple of hours, so it was fully warmed up.

I shut it down for a few minutes and it wouldn't start back up. It
turned over, but wouldn't start, no matter where I set the 3 position
choke.

I tried to start it a few times over the next few days, making sure it
was cold and following the cold start procedure. No luck, it wouldn't
start.

It was the end of the season, so I dumped the gas and stuck it in the
shed, where it's sat for the last 4+ months.

The Current Problem:

Yesterday I pulled it out, changed the spark plug, sprayed the
carburetor with cleaner and put in fresh 32:1 gas/oil.

I pumped it up, closed the choke and it started on 3 pulls.

The problem now is that it only runs with the choke fully closed. As
soon as I move the choke lever to Partial or fully Open, it gives up a
deep throaty sound for half a second as it stalls. It's almost like a
kill switch. There's no surging or rough running, it just shuts down.