On 2010-05-10, Carl Ijames wrote:
We use a couple of tumblers at work mostly to deburr little 304SS brackets
and stuff, with cylindrical ceramic media 1/4" diameter with the ends cut at
a 45 deg bevel so the ends are pretty sharp. Twenty minutes or so rounds
the edges and smoothes everything out, and leaves the surface covered with
little "dings" that you really can't feel but can see. These are 1-4" by
1-4"-ish, 20 and 16 ga, sized pieces. If something is too heavy it drops to
the bottom and doesn't "tumble", so you will have to experiment with yours
to see what the limit is - I doubt if the vise body itself will work. I've

Yes, the body will not work. I think that I will just throw this into
the muriatic acid bucket and will play with something else in the
tumbler.

done some small pieces of hot rolled and cold rolled with scale and rust
(just before we were throwing away the media so I didn't get screamed at
:-)), and it took off the rust but didn't really cut the scale. Our media
won't go into small holes, but smaller media cuts a lot slower. Those flat
triangles would probably be better if you have small nooks and crannies.
Anyway, should work for the hardware but not the body and the moveable jaw.

OK, I am sure that I will find some uses for it. Does tumbling ruin threads
on bolts?

i