I have them on a 14" Delta and they work just fine. Install them per
instructions and use them. You don't need a .001" slip fit on these.

--
Bill Rittner
R & B ENTERPRISES
Manchester, CT



"Don't take this life too seriously.......nobody
gets out alive" (Unknown)

Remove "no" to reply
Greg G. wrote in message
...

Just picked up a set of Cool Blocks from Highland Hardware.
Went to install them and noticed that they don't fit well at all.
Measured the old blocks, exactly 1/2"
Measured the Cool Blocks, they are 1/32" shy on all dimensions.
Makes for a pretty sloppy fit and it's hard to make the faces parallel
to the blade and stay that way when tightening.

Can anyone who uses these things tell me if this is normal, or did I
get a bum batch?

Thanks,

Greg G.