View Single Post
  #6   Report Post  
Posted to rec.crafts.metalworking
Gunner Asch[_6_] Gunner Asch[_6_] is offline
external usenet poster
 
Posts: 10,399
Default Questions about InecoBasic Pipe Bending Machine

On Wed, 21 Apr 2010 17:21:15 -0400, "Michael A. Terrell"
wrote:


Gunner Asch wrote:

On Tue, 20 Apr 2010 22:28:48 -0400, "Michael A. Terrell"
wrote:


Gunner Asch wrote:

On Tue, 20 Apr 2010 20:07:40 -0400, "Michael A. Terrell"
wrote:


Is anyone familiar with this machine, or the Yaskawa VS-mini J7 VFD it
uses?

The Yaskawa vfd..Im quite familar with. Its virtually bullet proof. One
of the best VFDs out there.


The machine doesn't respond to the controls. The display shows what
it's supposed to, but you hit the footswitch and the error light starts
flashing. The replies from Ineco are in very broken English and all
say, "If not work after this, replace the circuit board."



I just downloaded the manual for you, and emailed it to your email
address.


Which manual? I found the Yaskawa VS-mini J7 manual online, but I
didn't have my computer glasses with me at the site. My friend called
to tell me that Ineco told them the 208 volts wouldn't run it, so I was
only supposed to show them how to install a boost transformer. I showed
them and checked their wiring, but the machine still doesn't work. As I
was leaving for the day they admitted that they sometimes had to run it
with the display not working.

The Ineco website was hacked, and the equipment manual was replaced by
the hacker's ID, in an 18 byte file.


Post the exact model number of your drive. I may..may have a spare
display out in the shop.

If you have the display/local control that plugs into the front of
it..you can run the thing manually while testing.

Check your earthlink mailbox.



I fixed it. The idiot 'wire monkey' screwed up the electrical
install. One end of the run was 208 volts, and the other was 120
volts. The owner assured me the new wiring was correct, until I showed
him 136 volts after the boost transformer he installed. After the wire
monkey installed the right breaker, I had 237.6 volts at the power
switch on the Ineco Basic.

I will try to get a good scan of the entire Ineco manual, in case
somone else needs a copy.



Cool!

Gunner


"First Law of Leftist Debate
The more you present a leftist with factual evidence
that is counter to his preconceived world view and the
more difficult it becomes for him to refute it without
losing face the chance of him calling you a racist, bigot,
homophobe approaches infinity.

This is despite the thread you are in having not mentioned
race or sexual preference in any way that is relevant to
the subject." Grey Ghost