On Sun, 28 Mar 2010 06:44:58 -0700 (PDT), GarageWoodworks
wrote:
On Mar 27, 3:43*am, GarageWoodworks
wrote:
Just put this together:
http://www.garagewoodworks.com/video.php
Comments welcomed.
Thanks to all that checked out the video! Like I said at the end,
there are a half-dozen other ways to do this, but this is my
preferred.
I sincerely appreciate your feedback.
--with the exception of one mean dude. :^(
I really like your videos and have learned a lot from them (and will review
them as needed
. I too was disappointed in the "sneak up on" advice. That's
the part that always bites me. The jig is a fantastic idea (a hint on how to
make them would be nice) and I'll steal that part, however I'll do my best to
figure out a way around the "sneak up on" part.
IS there a reason you used such a small router bit? It would seem like a 1/2"
bit in a 3/4" bushing, or some such, would be easier and give a known "sneak
up" factor.