I guess I just fast forwarded to fast.

On Mar 23, 10:24*am, "CW" wrote:
"SonomaProducts.com" wrote in message

...
I had always seen them used for joining face frames and boxes. and
stuff like that. Using them across the joint of a panel was new to
me.

My proof points that it is somewhat uncommon a

* *- All of the accessories Kreg sells are vice grips for holding down
face frame type joints, etc.
* *- The Kreg little hand held drill guides have two or three paired
holes, great for face frame sticks. But no big wide jig with a few far
spaced holes that would be good for a panel.
* *- I just fast forwarded through the "Joinery 101" video on the Kreg
site and the closest thing they show to a panel joint is a stave type
glue up with beveled edges (near end of video). They never show a true
flat panel.

Yes they do. Twice.