"John Grossbohlin" wrote in
m:

http://zo-d.com/stuff/how-do-i/how-t...framing-square
.html

I've heard of this approach, and the large square is probably close enough
to give it a shot. I suspect I'd have to beat the hell out of the smaller
square to get is closr to right.

I'll report back on how it goes. I can probably use my machinists square
to get started. It's not clear how precisely I can draw and check the
lines, but over the long leg, I should be able to get pretty close. I may
also start by stoning out any nicks & dings, and then I can use a precision
straight edge for the "base" of the alignment test.

Doug White