On Wed, 16 Dec 2009 00:21:45 -0800, Jon Danniken wrote:
I tightened up a 1/4" lag screw that I bought from Home Depot earlier this
evening. It was screwed into 1.5" fir after pre-drilling with a 1/8" pilot
hole.

After it bottomed out, I turned it just a little bit more, holding a 3/8"
ratchet handle close to the shaft, not out on the handle. I wasn't giving
it much torque, just making sure that it was secure, when it turned to
butter.

1/4"? What's that for, a doll house?