How often do you check the setup of your TS?
"Bill" wrote in message
...
Snip
Drafting square sets both blade and miter angle. Gets used
every time.
---
By drafting square, do you mean a plastic protractor, or something else?
Probably refering to a drafting "triangle", typically thin transparent or
translucent triangles in 45-45-90 or 30-60-90 degree orientations. Not to
be confused with a T-Square.
Your comment on the throatplate below is well-taken. I'm surprised there
are so many "worthless" ones in circulation.
Probably about 1 with each new saw. ;~)
|