View Single Post
  #21   Report Post  
Posted to alt.engineering.electrical,sci.electronics.components,sci.electronics.design,sci.electronics.repair
Ian Jackson[_2_] Ian Jackson[_2_] is offline
external usenet poster
 
Posts: 1,383
Default Help identifying dead electro. cap polarity?

In message
,
George Herold writes
On Nov 12, 3:10*am, notme wrote:
The markings are clearly 1, 2 and 3 with the fourth a NEGATIVE sign


To me they look like "1" (not a "-"), "2", "3", and a really weird "4".

Is not the negative sign *right next* to the pin linked to the case


But with your help along with the one pin (yes, it's the (-) one) in common
with the case pretty much confirms polarity.

Thanks!

Nighty-night! Lights out!


Ahh but it's german. They make the 1 with that little hat.



And then
when they make a 7 they always add a cross through the middle... so as
not to confuse it with the one.

The Germans (and those in many other Continental European countries)
certainly do that when WRITING the number 7. However, I can't recall
ever seeing it on a PRINTED 7. This is (of course) because they start
writing a 1 (one) with a long slanted up-stroke, followed by a vertical
down-stroke. As such, it's not unlike an 'artistically' written 7. The
addition of a horizontal stroke through the vertical down-stroke of the
7 prevents it from being confused with a 1. With a printed 7, the top
stroke is definitely horizontal, and there is no confusion.

Most non-Europeans write a 1 (one) as a single vertical down-stroke, so
there is no possibility of confusion between a 1 and a 7. However, if
you decide to embellish a 1 with the short slanted up-stroke at the top
and the foot at the bottom, you have to be careful that it cannot be
confused with a 2.
--
Ian