Pre-mitred kitchen worktops
"Perry (News)" wrote in message
...
I'm replacing the worktops in our utility room which, in itself, isn't
a problem as it's a nice, rectangular shape with worktops down two
sides, but I need a mitred right-angle join - I've never cut one of
these before and understand that it's a bit of a steep learning curve
for a one-off job, so I wondered if anyone knows anywhere around the
Worthing/Brighton area that will sell a worktop pre-mitred and routed
for the butterfly bolts
Perry
Usually done on site and not cheap.
It's not really a steep learning curve if you've a proper template and a
router.
As a precaution don't cut the worktops to length until the mitre is done.
Then you'll have scope for another go if you b. it up.
mark
|