"Joe" wrote in message
...

A good default ratio is the golden mean.
http://en.wikipedia.org/wiki/Golden_ratio

--
Nonny


I know about the golden mean. can you elaborate on the
calculation you'd use to get to the width of the breadboard end
with this method? I guess I'm not seeting how you'd apply it.

thanks

Joe, I was of the opinion you had the width worked out and the
overall length, less the ends was known as well. If I was doing
it, I'd take the width, multiply by 1.6 or 1.7, then subtract the
existing length and divide by 2.


--
Nonny

Have you ever wondered if the bills
in your wallet were ever in a stripper's butt crack?
Have a nice day ..