View Single Post
  #104   Report Post  
Posted to alt.home.repair
JIMMIE JIMMIE is offline
external usenet poster
 
Posts: 1,417
Default Load capacity of 200-amp panel

On Oct 28, 3:59*pm, wrote:
On Oct 28, 1:37*pm, bud-- wrote:





wrote:


Yes. * You have a 3 wire service cable coming into the house. * Use
Kirchoff's law and add up the current coming into the house at any
point in time under any conditions through that cable any you have a
max of 200 amps. * Add up all the current leaving the house at the
same point in time and you have a max of 200 amps. * *In my world,
that's a 200 amp service. * You don't measure 300, or 400 by counting
electrons twice.


And also, to support a max of 400 amps of 120volt load in the house
which is the hot topic, you have to have the special case where the
loads are perfectly balanced so that 200 amps is on each side.


To get the max of 200A of 240V load you have to have the special case
where the loads add up to 200A. The discussion is about the special
cases of a fully loaded service.


*And
then you in fact have a SINGLE circuit with 200 amps flowing in on one
hot leg, throught the loads in series, and back out the other hot
leg. *Nothing flows in the neutral. * *Again, in my world, that's 200
amps flowing in the service, not 400.


What did the OP want to know?
IMHO, the OP was asking how many amps of 120V load you can hang on a
200A 240V service. The correct answer is 400.


--
bud--


The correct answer is actually 400 amps of 120volt load IF THE LOAD IS
PERFECTLY BALANCED. * IF it's anything less than perfectly balanced,
you can not support 400amps of load. *If it's totally unbalanced, you
only get 200 amps.. *Partially ballanced, you get between 200 and
400. * *The only way you can get 400 is if it is perfectly balanced so
that the 120volt loads are in SERIES and appear as a 200 amp 240volt
load.

Agree?- Hide quoted text -

- Show quoted text -


No, if the load is balanced there is no 120 volt loads just 240s. 240
X 20 also equal 48KW.

If what you were saying is true you could hang your ammeter on the
neutral line and measure 400 amps.

It doesnt just appear to be a 240 volt 200 amp load IT IS. The two
loads are in series, same electrons going through both of them. Its
not fair to count electrons twice.

Jimmie