Seal between tiles and bath?
On 26 Oct, 09:45, Andy Cap wrote:
On Mon, 26 Oct 2009 09:01:41 +0000 (UTC), (Andrew
Gabriel) wrote:
Having found dry rot when pulling out the old bath due to leakage
at this join (fortunately not serious in this case), I was rather
concerned to make sure that couldn't happen again. I put a wide
strip of silicone along the two bath edges which butt against the
wall and slid the bath into place. 7 years later, nothing has
leaked through the join. On the visible surface, the join is
simply grouted, along with all the tiles.
Mind you, I dread the day I have to remove the bath...
I did similar. Waterproofed the wall. Put a bead of silicone on that before
putting the bath in place. Then a bead of sealant into the gap. Then tiled. Then
applied the final bead of sealant. I have just redone that after about 10 years.
Andy C
I did that. BAL WP1 on wall, and the 3 stage silicone approach. I
thought "no chance any water will get past all that"!
Also, loads of timber under the bath to support it.
Simon.
|