In article , "CW" wrote:

"Doug Miller" wrote in message
...
In article
,
DerbyDad03 wrote:
On Oct 1, 8:08=A0am, (Doug Miller) wrote:

C. Use a lathe

Neither will that.

Sure it will. You just have to make sure you lift your turning tools
at the correct times. g

OK, wise guy, back atcha -- tell me how you're going to mount that between
centers to get the 3" radius the OP wanted. g

Block on each end large enough to take the centers for the correct offset. I
thought that was obvious but apaerently not.


The vibration from being so far off balance would tear it off those blocks in
a heartbeat.