Aaron Fude wrote:
Hi,

I have 3"x3" lumber and I would like to do one of two things:

1. Make a 3" quarter round, or

A. Use a router and 1 1/2" radius router bit, $114.71 here...
http://www.eagleamerica.com/product/v156-0102

B. Cut into octogan, quarter it, plane/spokeshave/sand to round

C. Use a lathe
_________________

2. Make a "diagonal" cut so that the lumber has a triangular 3"x3"x
profile.

A. Tilt bandsaw table

B. (better IMO) Make an auxiliary table with a cradle of two pieces mounted
at 90 degrees to each other and 45 degrees to the table, use on either
bandsaw or table saw. On table saw, cut in two passes; i.e., depth at 1
1/2" or less, cut once, flip vertically, cut again.

--

dadiOH
____________________________

dadiOH's dandies v3.06...
....a help file of info about MP3s, recording from
LP/cassette and tips & tricks on this and that.
Get it at http://mysite.verizon.net/xico