In article
,
Rob G wrote:
On 25 Aug, 21:08, Tim S wrote:
The Medway Handyman coughed up some electrons that declared:

Tim S wrote:
a 3/4" BSP tap - is that a parallel BSP thread? I'm pretty sure it
is but I want to check before I go and order the bits to connect
the bath taps (and likewise the 1/2" taps on the basin)...

There is only 1 type of tap connector thread AFAIK.

Use flexibles.

Any particular recommendation for make? I can see the merit - no
trying to bend a copper pipe to the mm.

Are their any cons - (relatively) short life etc?

Ta

Tim

The con is that the flexibles do not supply a rigid base for the tap
and it is difficult to get the tap to lock onto the bath/sink.

I'd guess the same with plastic pipe. Especially with one hole fixings.

--
*I'm already visualizing the duct tape over your mouth

Dave Plowman London SW
To e-mail, change noise into sound.