"Spehro Pefhany" wrote in message
...
On Wed, 15 Jul 2009 12:48:08 -0700, "Richard W."
wrote:


"Spehro Pefhany" wrote in message
. ..
Going to be looking at a Frejoth mill with Mitut. DRO and a bit of
tooling and variable speed head.

Are these these things any good? Range of price that would be
reasonable?



They have been around since the early 1980's and I have heard good
reports.
Yet I have never used one. Price would depend on the model and condition.
All this is unknown since you didn't say.

Richard W.


All the info I have except that the asking price is about $1800 USD
What model and condition would make that a good deal (doesn't have to
be a 'steal')?


I would think that would be a good deal if it's not worn out. The options
were step head and 9 X 42" or 9 X 49" table and step head or variable speed
head. Don't know if they had a 10 X 50" table back then. You can always ask
if they will take less.

Richard W.