GMM wrote:
I need to send a (network, not power!) cable through a door frame.
The plan is to go through the plaster beside the frame (a couple of
inches before an adjoining door), at a bit of an angle to come out on
the edge of the architrave on the other side. The total depth of this
hole will be 200 - 250mm (well, 8 - 10 inches anyway) and most of it
will be through timber.
Soooooo....I was trying to find a drill long enough to get through
that lot. Plenty of masonry jobbies to be had, SDS or not, but
they're not very good on timber. The only things I can find are
extended flat bits (which might be tricky to get going at the angle I
need) and augur bits, which might be fine but really should be in a
brace and a) I haven't got one and b) I couldn't turn a brace in that
position.

Flat bit and extension bar will do what you want - just drill as far as
the wood with a masonry bit, and carry on with the flat bit.

Failing that, the brute force and ignorance solution would just romp
through with the SDS. It may not drill the wood as such, but it won't
stop it!


--
Cheers,

John.

/================================================== ===============\
| Internode Ltd - http://www.internode.co.uk |
|-----------------------------------------------------------------|
| John Rumm - john(at)internode(dot)co(dot)uk |
\================================================= ================/