On Jun 3, 9:08*am, Steve Barker wrote:
Michael A. Terrell wrote:
Bob Larter wrote:
William R. Walsh wrote:
Hi!

The obvious solution to this problem is to buy laundry equipment with
conventional electro-mechanical controls. (Assuming they're still made.)
They most certainly are. It's still quite possible to buy (at least in the
US) a washer or dryer with conventional, non-microcontroller-based controls.
Even some of these fancy-dancy front loaders are made that way:
http://greyghost.mooo.com/doingthela...er.jpg(494x691,
20KB).

I've been inside it once, and the internals are what you'd expect of a
machine much older. The timer is a simple mechanical one, water level is
detected by vacuum, and while the drum motor has an electronic controller,
it looks to be well made.

How it's possible to not make the microcontroller-based controls work
reliably for years and years is beyond me. Makers of microwave ovens have
managed to do so for years. I've *never* seen a microwave oven with a dead
control panel.
I have, several times.

* *Dozens of them.

I've never seen a microwave quit for any reason. *AND if it did, i'd get
out another $69 and buy a new one.


Exactly. I just tossed away a 23 year old Jenn Air microwave that had
electronics and it was still working fine. I'm not convinced the
premise that washers and dryers with electronics are inherently more
prone to failure than other units is valid. I see most people in
this group with actual problems that are in the area of switches,
motors, water level sensors, solenoid water valves, etc.

Also, if you want to go a long way to protecting ALL your appliances
and electronics, you should install a whole house surge protector.