I jumped in on this pretty late, but how many conductors are in the cable
you are using to power up your saw? I would be surprised if you actually
had a neutral going there, but if you did, you could pull 120 into a
receptacle. I wouldnt want it to be used at the same time the saw was
working though.


"Steve McDonald" wrote in message
...
Thank you in advance!

I am wiring up a 110V outlet to go on the side of my table saw outfeed
extension table recently built.
I would like to tap this off of the 220V outlet for the table saw,
directly
beneath the new bench.
I know I can get 110 from this by putting the black wire on one of the
220V
outlets hot post and the
white wire on the neutral ...now...should the green wire (in the cord
going
to the new outlet) also
go to the same post as the white / neutral since both are at ground
potential?

Steve